Over Torque Fault. OverTorquing The Hidden Culprit Behind Equipment Failures To close the bonnet, rotate the bonnet downward over the globe, applying slight inward pressure at the latches to align the bonnet within the base Make sure the litter is just below the raised fill line
OVER TIGHTENED / OVER TORQUED WHEEL NUTS CAN CAUSE MAJOR PROBLEMS ON from www.youtube.com
Litter-Robot 4: Red with yellow flashing (Over-torque fault) and part replacement Hi! Thank you for the tip but I dont think I have the same issue unfortunately
OVER TIGHTENED / OVER TORQUED WHEEL NUTS CAN CAUSE MAJOR PROBLEMS ON
Posted by u/Dizzy-Researcher-390 - 9 votes and 5 comments Check to make sure the center tab at the top of the bonnet is secured in its pocket by pushing down on the bonnet at the tab location Does anyone else get an over torque fault just about every time the machine cycles? It fixes itself 99% of the time, but I hate the notifications and don't want to turn them off in case it's one of the few times it doesn't resolve
Nonstop Over Torque Fault. I’ve tried everything. No response from. Litter-Robot 4 I am at my wits end with my Litter Robot 4 To close the bonnet, rotate the bonnet downward over the globe, applying slight inward pressure at the latches to align the bonnet within the base
OverTorquing The Hidden Culprit Behind Equipment Failures. This causes the motor to stop and will display yellow and red lights blinking in sequence. Hi! Thank you for the tip but I dont think I have the same issue unfortunately